1. Higher requirements for lubrication and cooling.
2. Good compatibility. Worm and gear are manufactured according to national standards. Bearings and oil seals are made of standard parts.
3. There are two types of input shaft connection: basic type (single input shaft and double input shaft) and flange with motor.
4. Basic (vertical or horizontal with pedals) and ordinary (rectangular with fixed screw holes on many sides, without pedals or with pedals).
5, smooth transmission, vibration, impact, low noise, large reduction ratio, wide versatility, can be used with all kinds of mechanical equipment.
3. The position directions of the output shaft and input shaft are below and above the input shaft; Axial output up and down; Up and down input shaft.
7. Two or three reducers can be used to form a multistage reducer to obtain a large transmission ratio.
8. Large transmission ratio can be obtained through single stage transmission, compact structure. Most models of reducer self-locking, braking requirements for mechanical equipment can be omitted.
9. The meshing friction loss between worm thread and worm gear tooth surface is large, so the transmission efficiency is lower than that of gear, and it is easy to generate heat and high temperature.
Working conditions of WP series reducer:
1. Worm speed of worm gear reducer should not exceed 1500 RPM.
2. The operating temperature is -40℃-+40℃. When the working environment temperature is below 0℃, the lubricating oil must be heated to above 0℃ before starting. When the ambient temperature is higher than 40 ° C, cooling measures must be taken.
3. Worm gear reducer can rotate forward and backward.
