Product Description :WP series worm reducer is developed on the basis of WD reducer. The worm is made of 45# steel after heat treatment, and the worm wheel is cast in tin bronze. It has good wear resistance, especially in carrying capacity. Main structure and performance characteristics of the product:
1, smooth transmission, vibration, impact, noise is relatively small, deceleration ratio is large, can be matched with all kinds of mechanical equipment.
2, with single stage transmission can obtain larger speed ratio, compact structure. Most models of reducer have good self-locking, for mechanical equipment with braking requirements, can omit the braking device.
3. The meshing friction loss between worm thread and worm gear tooth surface is large, so the transmission efficiency is lower than that of gear, easy to heat up, and the temperature is relatively high.
4, higher requirements for lubrication and cooling.
5, good mutual company. The worm and gear are made to standard. Bearings and oil seals are made from standard parts.
6, the box has basic type (vertical and horizontal with foot pedal) and type (multi-sided with fixed screw hole rectangular shape, without foot pedal, with additional foot pedal) two.
7, there are two types of input shaft connection: basic type (single input shaft and double input shaft) and flange with motor.
8, two or three reducer can be composed of multi-level reducer, in order to obtain a large transmission ratio. Working conditions: worm speed of worm gear reducer should not exceed 1500 RPM. Working environment temperature is -40℃ to 40℃. When the working environment temperature is below 0℃, the lubricating oil must be heated to above 0℃ before starting; When the ambient temperature is higher than 40 ° C, cooling measures must be taken. Matters needing attention:
1. Cochlear wheel shaft cannot be used as input shaft.
2. The power of the supporting motor shall not exceed the value specified on the label.
3. If the user requires to change the direction of the input shaft, take the cover at both ends of the lower shaft, take out the worm shaft, and adjust it 180 degrees. Do not knock during installation, but turn the two shafts slowly to engage.
