At present,WPWE80-135,WPWE100-155,WPWE120-175,WPWE135-200,WPWE155-250 servo reducers are widely used in numerous industrial occasions due to their advantages such as small size, light weight, low noise, high accuracy, high transmission efficiency, and high load-bearing capacity. However, during the use of servo reducers, it is believed that many friends may have experienced the problem of "overheating". The occurrence of overheating problems will to some extent affect the normal use of servo reducers. In response to this situation, the following editor will introduce the causes and treatment methods of overheating in the servo reducer.
Reason for overheating of servo reducer:
1. Overload operation.
2. Excessive oil seal friction.
3. Excessive impact load.
4. The operating temperature is too high.
5. Improper connection between output shaft and transmission device.
6. Poor or inappropriate lubrication oil, or insufficient lubrication oil.
Overheating treatment method for servo reducer:
1. Adjust to the appropriate load.
2. Drip lubricating oil at the oil seal.
3. Change to a larger model gearbox.
4. When the operating temperature is too high, it is necessary to improve the ventilation environment.
5. Adjust the output shaft and transmission device of the servo reducer to the appropriate position.
6. Replace with appropriate lubricating oil and add appropriate lubricating oil according to instructions.
The above is for everyone to share the reasons and treatment methods for overheating of the servo reducer. During the use of servo reducers, it is inevitable that some small problems may occur due to various reasons, which cannot be avoided. However, for these small problems, we can analyze their causes and make corresponding solutions to ensure the normal operation of the servo reducer.
