WP reducer, also known as WP reducer, is divided into standard WPS series, standard WPD series, standard WPA, WPO. WPDA, WPDO, WPDS, WPDS, etc. WP worm gear reducer is developed on the basis of WD reducer. The worm is made of 45# steel after heat treatment, and the worm wheel is cast in tin bronze, which has good performance, especially bearing capacity. Worm gear reducer is mainly used for plastic, metallurgy, beverage, mining, lifting transportation, chemical construction and other mechanical equipment deceleration transmission.
1. Smooth transmission, low vibration, impact, noise, large reduction ratio, wide versatility, can be used with all kinds of mechanical equipment.
2. Large transmission ratio can be obtained through single stage transmission, compact structure. Most models of reducer have good self-locking, for mechanical equipment with braking requirements, can omit the braking device.
3. The meshing friction loss between worm thread and worm gear tooth surface is large, so the transmission efficiency is lower than that of gear, and it is easy to heat and high temperature.
4. Higher requirements for lubrication and cooling.
5. Good compatibility. The worm and gear are made to standard. Bearings and oil seals are made from standard parts.
6. The box has basic type (the box is vertical or horizontal with pedals) and type (the box is rectangular with fixed screw holes on many sides, without pedals or with other pedals).
7. There are two types of input shaft connection: basic type (single input shaft and double input shaft) and with motor flange.
8. The position direction of output shaft and input shaft has input shaft below and above; Axial output up and down; Up and down input shaft.
9. Two or three reducers can be used to form a multistage reducer to obtain a large transmission ratio.
